User Manual
Table Of Contents
- Online User's Guide DCP-J1200W
- Table of Contents
- Before You Use Your Machine
- Introduction to Your Machine
- Paper Handling
- Print
- Print from Your Computer (Windows)
- Print a Photo (Windows)
- Print a Document (Windows)
- Cancel a Print Job (Windows)
- Print More Than One Page on a Single Sheet of Paper (N in 1) (Windows)
- Print as a Poster (Windows)
- Print on Both Sides of the Paper Manually (Manual 2-sided Printing) (Windows)
- Print as a Booklet Manually (Windows)
- Print a Colour Document in Greyscale (Windows)
- Prevent Smudged Printouts and Paper Jams (Windows)
- Use a Preset Print Profile (Windows)
- Change the Default Print Settings (Windows)
- Print Settings (Windows)
- Print from Your Computer (Mac)
- Print Using Brother iPrint&Scan (Windows/Mac)
- Print an Email Attachment
- Print from Your Computer (Windows)
- Scan
- Scan Using the Buttons on Your Brother Machine
- Scan Using Brother iPrint&Scan (Windows/Mac)
- Scan from Your Computer (Windows)
- Scan from Your Computer (Mac)
- Copy
- Network
- Supported Basic Network Features
- Configure Network Settings
- Wireless Network Settings
- Use the Wireless Network
- Before Configuring Your Machine for a Wireless Network
- Configure Your Machine for a Wireless Network Using the Setup Wizard from Your Computer
- Configure Your Machine for a Wireless Network Using the Setup Wizard from Your Mobile Device
- Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Machine for a Wireless Network Using the PIN Method of Wi-Fi Protected Setup™ (WPS)
- Use Wireless Direct
- Enable/Disable Wireless LAN
- Print the WLAN Report
- Use the Wireless Network
- Network Features
- Brother Management Tools
- Security
- Before Using Network Security Features
- Configure Certificates for Device Security
- Use SSL/TLS
- Mobile Connect
- Brother iPrint&Scan for Windows and Mac
- Troubleshooting
- Routine Maintenance
- Replace the Ink Cartridges
- Clean Your Brother Machine
- Clean the Scanner
- Clean the Print Head from Your Brother Machine
- Clean the Print Head Using Web Based Management
- Clean the Print Head from Your Computer (Windows)
- Clean the Outside of the Machine
- Clean the Machine's Printer Platen
- Clean the Paper Feed Rollers
- Clean the Base Pad
- Clean the Paper Pick-up Rollers
- Check Your Brother Machine
- Check the Print Alignment from Your Brother Machine
- Check the Print Alignment Using Web Based Management
- Change the Print Options to Improve Your Print Results
- Pack and Ship Your Machine
- Machine Settings
- Appendix
6. COLOUR COPY
• Press to start making copies in full colour.
7. Ink LED
Indicates when the machine detects an ink error or is in Maintenance Mode.
8. Warning LED
Indicates when the machine detects an error or is in Reset Mode.
9. (STOP) Power On/Off
• Press to stop an operation.
• Press to exit from a selected mode.
• Press (STOP) to turn on the machine.
Press and hold down
(STOP) to turn off the machine and cancel all of the remaining operations. The
Power LED blinks and stays on for a few seconds before turning itself off.
If you turn off the machine using (STOP), it will still clean the print head periodically to maintain print
quality. To prolong print head life, provide better ink efficiency, and maintain print quality, keep your
machine connected to a power source at all times.
10. (Wi-Fi)
• Press the button by itself or simultaneously with another button to configure the wireless settings or print
network reports. Use only when the machine is idle.
• Press this button and COLOUR COPY simultaneously to restart the Wi-Fi if you cannot connect to your
wireless network.
• Press simultaneously with
(STOP) to access the Wi-Fi Mode.
Related Information
• Introduction to Your Machine
10