User Manual
Table Of Contents
- User’s Guide DS-620 / DS-720D
- Using the documentation
- Trademarks
- Table of Contents
- 1 General Information
- 2 Installing the Scanner Driver and Scanning Software
- 3 Document Specifications
- 4 Scan Preparation
- 5 Scanning Applications and Settings
- Choosing your scanning software
- Using DSmobileCapture (for Windows®)
- Changing DSmobileCapture scan settings (for Windows®)
- Using DSmobileCapture (for Macintosh)
- Changing DSmobileCapture scan settings (for Macintosh)
- Using Button Manager V2 (for Windows®)
- Scan buttons in the Button Manager V2 Button Panel (for Windows®)
- 6 Scanner Calibration
- 7 Scanner Maintenance
- 8 Troubleshooting
- Appendix A
- Appendix B
Scanner Calibration
39
6
f Hold the edges of the Calibration Sheet and insert it into the feeder slot as shown below.
Click OK.
NOTE
Hold only the edges of the Calibration Sheet and be careful not to touch the white or black area.
Leaving marks or fingerprints on this sheet can cause errors in calibration.
g Scanning starts automatically.
h After the Calibration Sheet is scanned, a Calibration was successful message appears on your screen,
indicating that calibration finished successfully. Click OK to end calibration.
NOTE
If a Calibration failed message appears on your screen, remove the Micro USB Cable from your computer.
Reconnect the Micro USB Cable to the computer and perform the calibration again. If calibration fails again,
check the scanner’s print head to ensure it is clean.