Instruction manual

3. Getting Started

３-３. Preparing Your PC

This section describes how to install the GT-782 Printer Driver (FileOutput), manuals (Basic Operation Manual/ Instruction

Manual), Brother GT File Viewer, and other tools. Make sure the steps because there are some different dialogs shown

between Windows XP and Vista / Windows 7.

After those installations are over, install GT-782 Printer Driver (USB) by connecting USB 2.0 cable.

3-3-1. When you already have GT-541

When you already have GT-541, upgrade first to the latest printer driver (ver. 2.0.6 or above) before installing GT-782

to your PC. If you install GT-782 first and then need installing GT-541 later, be sure to install the latest printer driver

(ver. 2.0.6 or above).

You can get the latest version by downloading the Web site. Or make contact to your dealer or Brother.

<Note>

 In case that the GT-541 is not the latest version, you can normally install GT-782 but can not uninstall GT-541 normally:

the relation between ARP files and GT File Viewer disappears. In this case, re-install GT-782. See "3-3-2. PC

preparation: For Windows XP" or "3-3-6. Installation of PC for Windows Vista / Windows 7" and execute "Setup.exe".

 In case that you install the lower version GT-541 (below 2.0.6) to the PC that GT-782 has been already installed,

installation fails and the error message below appears. Install the latest version.

(Continued on the next page)

GT-782