User Guide

6-14
The following steps apply to configuring a remote printer on NetWare 3.xx
systems:
6.
a Select Print Server Information from the PCONSOLE main menu and
choose the name of the PSERVER NLM.
b Select Print Server Configuration and then Printer Configuration. Select
any "Not Installed" printer and press Enter. Remember the number of this
printer, since it will be used later in the configuration process.
c If desired, type in a new name for the printer.
dGo to Type, press ENTER, highlight Remote Other/Unknown and press
ENTER again. The other settings in this menu are not required.
e Push ESCAPE and save the changes.
f Push ESCAPE and select Queues Serviced by Printer.
g Highlight the printer name that you just configured and press ENTER.
h Press INSERT, choose the desired print queue, and press ENTER (you can
accept the default priority).
i Press ESCAPE several times to exit PCONSOLE.
Assigning the Remote printer name and number using BRCONFIG
7.
a Execute the BRCONFIG from the Windows menu or insert the Brother
Print Server Software diskette in Drive A: of your PC and type:
A:BRCONFIG
b Select the Brother print server from the list of print servers. When you get
the message that the print server is connected, press the ENTER key and
type Where the default password “access” in response to the “#” prompt
(the password will not echo) and then press the ENTER key again in
response to the Enter Username> prompt. When you get the Local>
prompt, type:
SET NETWARE NPRINTER nlm number ON service
SET NETWARE RESCAN
EXIT