Quick Setup Guide
Table Of Contents
- Quick Setup Guide HL-3040CN
- Start Here
- For USB Interface Cable Users (For Windows® users)
- For USB Interface Cable Users (For Mac OS X users)
- For Wired Network Interface Cable Users (For Windows® users)
- For Wired Network Interface Cable Users (For Mac OS X users)
- For Network Users
- Other Information
- Safety precautions
- Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (USA only)
- Important
- Important - about the interface cable
- Radio interference
- Industry Canada Compliance Statement (Canada only)
- EC Declaration of Conformity
- International ENERGY STAR® Compliance Statement
- Disconnect device
- EU Directive 2002/96/EC and EN50419
- IMPORTANT - For Your Safety
- LAN connection
- Wiring information (UK only)
- Warning - This printer must be earthed.
- Shipment of the printer
- Repacking Instructions
- Supplied CD-ROM
- Control panel
- Options and Consumables
2
WARNING
• Plastic bags are used in the packaging of your printer. To avoid danger of suffocation, please keep
these bags away from babies and children.
• This printer is heavy and weighs approximately 41.9 lb. (19.0 kg). To prevent injuries use at least two
people to lift the printer. Be careful not to pinch your fingers when you put the printer back down.
Note
Keep the printer a gap roughly as shown in the illustration.
510mm (20.1 in.)
100mm
(4 in.)
100mm
(4 in.)
(
4.7 in.
)
120mm
(4.7 in.)
Note
The interface cable is not a standard accessory. Buy the appropriate interface cable for the interface you want to use (USB
or Network).
USB cable
• Please make sure you use a USB 2.0 (Type A/B) interface cable that is no longer than 6 feet (2 meters).
• When you use a USB cable, make sure you connect it to the USB port of your computer and not to a USB port on a
keyboard or non-powered USB hub.
Network cable
Use a straight-through Category5 (or greater) twisted-pair cable for 10BASE-T or 100BASE-TX Fast Ethernet Network.