Quick Setup Guide
Table Of Contents
- Quick Setup Guide HL-3040CN
- Start Here
- For USB Interface Cable Users (For Windows® users)
- For USB Interface Cable Users (For Mac OS X users)
- For Wired Network Interface Cable Users (For Windows® users)
- For Wired Network Interface Cable Users (For Mac OS X users)
- For Network Users
- Other Information
- Safety precautions
- Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (USA only)
- Important
- Important - about the interface cable
- Radio interference
- Industry Canada Compliance Statement (Canada only)
- EC Declaration of Conformity
- International ENERGY STAR® Compliance Statement
- Disconnect device
- EU Directive 2002/96/EC and EN50419
- IMPORTANT - For Your Safety
- LAN connection
- Wiring information (UK only)
- Warning - This printer must be earthed.
- Shipment of the printer
- Repacking Instructions
- Supplied CD-ROM
- Control panel
- Options and Consumables
27
Other Information
Shipment of the printer
If for any reason you must ship your printer, carefully
package the printer to avoid any damage during
transit. We recommend that you save and use the
original packaging. The printer should also be
adequately insured with the carrier.
CAUTION
When shipping the printer, the DRUM UNIT,
TONER CARTRIDGE assemblies and WASTE
TONER BOX must be removed from the printer
and put in a plastic bag. Failure to remove these
items and put them in a plastic bag before shipping
may cause severe damage to the printer and may
VOID THE WARRANTY.
Repacking Instructions
Make sure that you have the following parts for
repacking.
a Plastic bags – to be supplied by you, the user; one for
the waste toner box, and one each for the four drum and
toner cartridge assemblies
b Protective covers that the original drum and toner
cartridge assembly came with
c Packing material for locking the belt unit
WARNING
This printer is heavy and weights approximately
41.9 lb. (19.0 kg). To prevent injuries use at least
two people to lift the printer. Be careful not to
pinch your fingers when you put the printer back
down.
a Turn off the printer power switch, and then
unplug the AC power cord.
b Fully open the top cover and take out all the
drum unit and toner cartridge assemblies.
Attach the protective cover to each of the drum unit
and toner cartridge assemblies.
Put each assembly into a plastic bag and completely
seal each bag.
c Remove the belt unit by holding the green
handle and lifting the belt unit up and out of the
printer.
d Remove the waste toner box from the printer,
and then put it in a plastic bag and seal the bag
completely.