Quick Setup Guide
Table Of Contents
- Quick Setup Guide HL-3040CN
- Start Here
- For USB Interface Cable Users (For Windows® users)
- For USB Interface Cable Users (For Mac OS X users)
- For Wired Network Interface Cable Users (For Windows® users)
- For Wired Network Interface Cable Users (For Mac OS X users)
- For Network Users
- Other Information
- Safety precautions
- Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (USA only)
- Important
- Important - about the interface cable
- Radio interference
- Industry Canada Compliance Statement (Canada only)
- EC Declaration of Conformity
- International ENERGY STAR® Compliance Statement
- Disconnect device
- EU Directive 2002/96/EC and EN50419
- IMPORTANT - For Your Safety
- LAN connection
- Wiring information (UK only)
- Warning - This printer must be earthed.
- Shipment of the printer
- Repacking Instructions
- Supplied CD-ROM
- Control panel
- Options and Consumables
28
Other Information
e Reinstall the belt unit back in the printer.
f Reinstall the original packing material into the
printer.
g Close the top cover of the printer.
h Put the waste toner box in the Styrofoam piece.
i Using two people, place the printer into the
plastic bag.
j Put the printer and the Styrofoam pieces into
the carton. Match the front side of the printer to
the “FRONT” mark on the Styrofoam pieces.
Put the Styrofoam piece for the drum unit and
toner cartridge assemblies on the top of the
printer.
k Put the power cord, drum unit and toner
cartridge assemblies into the Styrofoam piece
as shown in the illustration.
l Put the two carton trays on the top.
m Close the carton and tape it shut.