User Guide
Table Of Contents
- Definitions of Warnings, Cautions, and Notes
- To Use the Printer Safely
- Printer Do's and Don'ts for Optimum Print Quality
- TABLE OF CONTENTS
- IMPORTANT INFORMATION: REGULATIONS
- CHAPTER 1 INTRODUCTION
- ABOUT THIS USER’S GUIDE
- ABOUT THIS PRINTER
- Checking the Components
- General View
- Features
- 2400 DPI Class Resolution
- High Speed and Color Laser Printing
- Color Advanced Photoscale Technology (CAPT)
- High Resolution Control (HRC)
- Maintenance-Free and Economical Toner Cartridge
- Universal Paper Cassette
- Three Interfaces
- Automatic Interface Selection
- Five Emulation Modes
- Automatic Emulation Selection
- Data Compression Technology
- Various Fonts
- CCITT G3/G4
- Panel Lock Function
- Power Save Mode
- Toner Save Mode
- Reprint Function
- PANTONE® Calibrated
- Network
- Options
- Compact Flash Card
- RAM
- Operating and Storage Environment
- CHAPTER 2 DRIVER AND SOFTWARE
- CHAPTER 3 BEFORE WORKING WITH THE PRINTER
- CHAPTER 4 CONTROL PANEL OPERATION
- CHAPTER 5 MAINTENANCE
- CHAPTER 6 OPTIONS
- CHAPTER 7 TROUBLE SHOOTING
- APPENDIX
- INDEX
CHAPTER 5 MAINTENANCE
5-15
4.
Take the Fuser Cleaner out of
the Fusing Unit by holding the
handle of the Fuser Cleaner as
shown below.
Fig. 5-8
5.
Install the new Fuser Cleaner
into the guide with the roller side
facing you.
Fig. 5-9
6.
Lock the Fuser Cleaner with the Fuser Cleaner Lock Levers.
7.
Close the Top Cover.
8.
Press the Power button to turn the printer On.
9.
Press any of the Menu buttons (+, –, Set or Back) to take the printer Off
Line.
10.
Press + or – until “RESET MENU” appears.
11.
Press Set to proceed to the next menu level, and then press + or – until
“PARTS LIFE” appears.
12.
Press Set, and then press +. “FC ROLLER” appears.
13.
Press Set, and then press Go. The printer is now in the READY state.