User Guide
Table Of Contents
- Definitions of Warnings, Cautions, and Notes
- To Use the Printer Safely
- Printer Do's and Don'ts for Optimum Print Quality
- TABLE OF CONTENTS
- IMPORTANT INFORMATION: REGULATIONS
- CHAPTER 1 INTRODUCTION
- ABOUT THIS USER’S GUIDE
- ABOUT THIS PRINTER
- Checking the Components
- General View
- Features
- 2400 DPI Class Resolution
- High Speed and Color Laser Printing
- Color Advanced Photoscale Technology (CAPT)
- High Resolution Control (HRC)
- Maintenance-Free and Economical Toner Cartridge
- Universal Paper Cassette
- Three Interfaces
- Automatic Interface Selection
- Five Emulation Modes
- Automatic Emulation Selection
- Data Compression Technology
- Various Fonts
- CCITT G3/G4
- Panel Lock Function
- Power Save Mode
- Toner Save Mode
- Reprint Function
- PANTONE® Calibrated
- Network
- Options
- Compact Flash Card
- RAM
- Operating and Storage Environment
- CHAPTER 2 DRIVER AND SOFTWARE
- CHAPTER 3 BEFORE WORKING WITH THE PRINTER
- CHAPTER 4 CONTROL PANEL OPERATION
- CHAPTER 5 MAINTENANCE
- CHAPTER 6 OPTIONS
- CHAPTER 7 TROUBLE SHOOTING
- APPENDIX
- INDEX
CHAPTER 5 MAINTENANCE
5-29
4.
Install the new Paper Discharger
into the Transfer Unit in the
reverse order that you removed
it.
Fig. 5-26
5.
Plug the power cord into the power outlet and press the Power button to
turn on the printer.
Note
•
User replacement of some of these parts is not recommended.
•
For replacement of the Paper Feeding Roller, Separator Pad and the
Transfer Drum, consult your local dealer/retailer.
•
Actions 6 to 9 should only be carried out by your dealer or Brother
authorized service center when they have replaced the Paper Feeding
Roller, Separator Pad and the Transfer Drum.
6.
Press any of the Menu buttons (+, –, Set or Back) to take the printer Off
Line.
7.
Press + or – until “RESET MENU” appears.
8.
Press Set to proceed to the next menu level, and then press + or – until
“PARTS LIFE” appears.
9.
Press Set, and then press + until “120K KIT” appears.
10.
Press Set, and then press Go. The printer is now in the READY state.