User Manual
Table Of Contents
- Using this guide
- Safety precautions
- Trademarks
- Compilation and Publication Notice
- Shipment of the Printer
- 1 About this Printer
- 2 Printing Methods
- 3 Driver and Software
- Printer driver
- Software
- 4 Control Panel
- 5 Options
- 6 Routine Maintenance
- 7 Troubleshooting
- Appendix A
- Printer specifications
- Symbol and character sets
- Quick reference for bar code control commands
- Print bar codes or expanded characters
- Definition of Parameters
- Bar code mode
- Bar Code, expanded character, line block drawing and box drawing
- Bar Code
- Bar code human readable line ON or OFF
- Quiet zone
- Bar code, expanded character unit, line block drawing and box drawing
- Bar code, expanded character, line block drawing and box drawing offset in X-axis
- Bar code & expanded character offset in Y-axis
- Bar code, expanded character, line block drawing and box drawing height
- Expanded character width, line block drawing and box drawing
- Expanded character rotation
- Bar code data start
- Box drawing
- Line block drawing
- Expanded character data start
- Print bar codes or expanded characters
- Appendix (For Europe and Other Countries) B
- Appendix (For USA and Canada) C
- Index
2. Printing Methods
14
e Put paper in the MP tray. Make sure that the paper stays under the maximum paper mark (b) on both
sides of the tray.
f While pressing the paper-guide release lever, slide the paper guide to fit the paper size.
g Send the print data to the printer.
Note
• The side to be printed on must be face up with the leading edge (top of the paper) in first.
• When printing on transparencies, remove each transparency at once after printing. Stacking the printed
transparencies may cause a paper jam or the transparency to curl.