User Manual
Table Of Contents
- Using this guide
- Safety precautions
- Trademarks
- Compilation and Publication Notice
- Shipment of the Printer
- 1 About this Printer
- 2 Printing Methods
- 3 Driver and Software
- Printer driver
- Software
- 4 Control Panel
- 5 Options
- 6 Routine Maintenance
- 7 Troubleshooting
- Appendix A
- Printer specifications
- Symbol and character sets
- Quick reference for bar code control commands
- Print bar codes or expanded characters
- Definition of Parameters
- Bar code mode
- Bar Code, expanded character, line block drawing and box drawing
- Bar Code
- Bar code human readable line ON or OFF
- Quiet zone
- Bar code, expanded character unit, line block drawing and box drawing
- Bar code, expanded character, line block drawing and box drawing offset in X-axis
- Bar code & expanded character offset in Y-axis
- Bar code, expanded character, line block drawing and box drawing height
- Expanded character width, line block drawing and box drawing
- Expanded character rotation
- Bar code data start
- Box drawing
- Line block drawing
- Expanded character data start
- Print bar codes or expanded characters
- Appendix (For Europe and Other Countries) B
- Appendix (For USA and Canada) C
- Index
4. Control Panel
49
Service call indications
If there is an error that cannot be cleared by the user, the printer will show that a service call is needed by
lighting up all the LEDs as shown below.
If you see the service call indication shown above, turn off the power switch, wait a few seconds, and then
turn it back on and try to print again.
If you cannot clear the error and see the same service call indication after turning the printer back on, call
your dealer or a Brother authorized service representative.
When you press Go and Job Cancel buttons together, the LEDs will light up as shown in the table below to
identify the error.
1
If this error occurs, turn off the printer power switch, wait a few seconds, and then turn it on again. Leave the printer for 10 minutes with the power
on. If the error occurs again, call your dealer or Brother authorized service representative.
2
If this error occurs, ensure that the DIMM is installed correctly. See Installing extra memory on page 58.
LED indications while pressing Go and Job Cancel
LEDs Main PCB
failure
Fuser unit
failure
1
Laser unit
failure
Main motor
failure
High voltage
failure
DIMM error
2
Toner
Drum
Paper
Status