User Manual
Table Of Contents
- Using this guide
- Safety precautions
- Trademarks
- Compilation and Publication Notice
- Shipment of the Printer
- 1 About this Printer
- 2 Printing Methods
- 3 Driver and Software
- Printer driver
- Software
- 4 Control Panel
- 5 Options
- 6 Routine Maintenance
- 7 Troubleshooting
- Appendix A
- Printer specifications
- Symbol and character sets
- Quick reference for bar code control commands
- Print bar codes or expanded characters
- Definition of Parameters
- Bar code mode
- Bar Code, expanded character, line block drawing and box drawing
- Bar Code
- Bar code human readable line ON or OFF
- Quiet zone
- Bar code, expanded character unit, line block drawing and box drawing
- Bar code, expanded character, line block drawing and box drawing offset in X-axis
- Bar code & expanded character offset in Y-axis
- Bar code, expanded character, line block drawing and box drawing height
- Expanded character width, line block drawing and box drawing
- Expanded character rotation
- Bar code data start
- Box drawing
- Line block drawing
- Expanded character data start
- Print bar codes or expanded characters
- Appendix (For Europe and Other Countries) B
- Appendix (For USA and Canada) C
- Index
7. Troubleshooting
82
Error message printout
The printer can also report problems by printing an error message. Use the table below to identify and clear
the error message.
Error message Action
MEMORY FULL Press Go to print the remaining data in the printer memory. Cancel the print job
if you want to delete the remaining data in the printer memory. See Control panel
buttons on page 51.
Reduce the complexity of your document or cut the print resolution.
Add more memory. See Installing extra memory on page 58
PRINT OVERRUN Press Go to print the remaining data in the printer memory. Cancel the print job
if you want to delete the remaining data in the printer memory. See Control panel
buttons on page 51.
If this does not clear the error, reduce the complexity of your document or cut the
print resolution.
Add more memory. See Installing extra memory on page 58.
Set page protection to AUTO by using the supplied Windows
®
driver or Remote
Printer Console program.
Change the following settings in the supplied Windows
®
driver and try again. The
best combination of these settings will vary depending on your document:
•Graphics mode
• TrueType mode
• Use Printer TrueType
®
Fonts
RESOLUTION REDUCED TO
ENABLE PRINTING
(The printer has printed the
document at a reduced
resolution)
Reduce the complexity of your document before you print to prevent automatic
reduction in the resolution.