Service manual

3-24

Confidential

 Top cover ASSY (For LCD models)

(5) Disconnect the LCD flat cable from the panel PCB ASSY.

(6) Release the hooks A, and remove the panel PCB ASSY from the top cover ASSY.

Release the panel PCB flat cable from the each guide on the top cover ASSY.

(7) Remove the rubber key from the top cover ASSY.

(8) Release the hooks B, and remove the LCD cover from the top cover ASSY.

(9) Release the hook C, and remove the LCD from the LCD cover.

Fig. 3-18

Harness routing: Refer to “3. Bottom side of the top cover ASSY”.

Note:

• After disconnecting flat cables, check that each cable is not damaged at its end or

short-circuited.

• When connecting flat cables, do not insert them at an angle. After insertion, check

that the cables are not at an angle.

Panel PCB flat cable

Hook C

LCD

LCD cover

Hooks B

Rubber key

Panel PCB ASSY

Hooks A

Top cover ASSY

LCD flat cable

Guides