User Manual

LED Indication Status Monitor Cause Action
Paper size available for
automatic 2-sided printing is A4.
The paper in the tray is not
the correct size and is not
available for automatic 2-
sided printing.
Load the correct size of paper in
the tray and set the tray for that
paper size.
Paper size available for
automatic 2-sided printing is A4.
Size Mismatch The paper in the tray is not
the correct size.
Load the correct size of paper in
the tray and set the size of paper
to the tray.
Manual Feed Manual was selected as the
paper source in the printer
driver, but there is no paper
in the manual feed slot.
Place paper in the manual feed
slot.
No Paper The machine is out of paper,
or paper is not loaded
correctly in the paper tray.
• Refill paper in the paper tray.
Make sure the paper guides
are set to the correct size.
• If paper is in the tray, remove
it and load it again. Make sure
the paper guides are set to
the correct size.
Toner Ended
(Continue mode)
It is time to replace the toner
cartridge.
Replace the toner cartridge with a
new one.
Self-Diagnostic The temperature of the fuser
unit does not rise to a
specified temperature within
the specified time.
Press and hold to turn the
machine off, wait a few seconds,
and then turn it on again. Leave
the machine idle for 15 minutes
with the power on.
The fuser unit is too hot.
Print Unable The machine has a
mechanical problem.
• Press and hold to turn
the machine off, wait a few
minutes, and then turn it on
again.
• If the problem continues,
contact Brother customer
service.
Related Information
• Troubleshooting
Related Topics:
• Replace Supplies
• Replace the Drum Unit
• Clean the Corona Wire
156