User Manual

Level 1 Level 2 Description
HP LaserJet Symbol Set
Select the symbol or character set.
Table Print
Print the code table.
Auto LF
ON: CR -> CR+LF, OFF: CR -> CR
Auto CR
ON: LF -> LF+CR, FF -> FF+CR, or VT -> VT+CR
OFF: LF -> LF, FF -> FF, or VT -> VT
Auto WRAP
Choose whether a line feed and carriage return will happen when the
machine reaches the right margin.
Auto SKIP
Choose whether a line feed and carriage return will happen when the
carriage position reaches the bottom margin.
Left Margin
Set the left margin at column 0 to 70 columns at 1 cpi.
Right Margin
Set the right margin at column 10 to 80 columns at 1 cpi.
Top Margin
Set the top margin distance from the top edge of the paper.
Bottom
Margin
Set the bottom margin distance from the bottom edge of the paper.
Lines
Set the number of lines on each page.
Tray Command
Select this setting if a tray mismatch appears when you use the HP
drivers.
BR-Script 3
(Available only for certain
models)
Error Print
Choose whether the machine prints the error information when errors
occur.
All other models
Level 1
Level 2 Description
Test Print
- Print a test page.
2-sided
(For automatic 2-sided
printing models)
2-sided
Print
Turn 2-sided printing off or on and select flip on long edge or short edge.
Single
Image
For a print job where the last page is a 1-sided image, select the 1-
sided Feed option to reduce printing time.
Auto Continue
- Select if you want the machine to clear paper size errors or media type
errors automatically.
Print Position X Offset
Move the print start position (at the top-left corner of pages) horizontally
up to -500 (left) to +500 (right) dots in 300 dpi.
Y Offset
Move the print start position (at the top-left corner of pages) vertically up
to -500 (up) to +500 (down) dots in 300 dpi.
[Network] (HL-L2350DW/HL-L2351DW)
Level 1
Level 2 Level 3 Level 4 Descriptions
WLAN TCP/IP Boot
Method
- Choose the IP method that best suits your
needs.
IP Address
- Enter the IP address.
Subnet
Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS
Config
- Select the WINS configuration mode.
237