User's Manual

• If you configure your machine using EAP-TLS authentication, you must install the client certificate
issued by a CA before you start configuration. Contact your network administrator about the client
certificate. If you have installed more than one certificate, we recommend writing down the certificate
name you want to use.
• If you verify your machine using the common name of the server certificate, we recommend writing
down the common name before you start configuration. Contact your network administrator about the
common name of the server certificate.
2. Press a or b to select the [Network] option, and then press OK.
3. Press a or b to select the [WLAN] option, and then press OK.
4. Press a or b to select the [Setup Wizard] option, and then press OK.
5. When [WLAN Enable?] appears, press a to select On.
This will start the wireless setup wizard. To cancel, press Cancel.
6. The machine will search for your network and display a list of available SSIDs. Press a or b to select the
[<New SSID>] option, and then press OK.
7. Enter the SSID name, and then press OK.
8. Press a or b to select the [Infrastructure] option, and then press OK.
9. Press a or b to select the Authentication Method you want, and then press OK.
10. Do one of the following:
• If you selected the [LEAP] option, enter the user ID, and then press OK.
Enter the Password, and then press OK.
• If you selected the [EAP-FAST], [PEAP] or [EAP-TTLS] option, press a or b to select the Inner
Authentication Method [NONE], [CHAP], [MS-CHAP], [MS-CHAPv2], [GTC] or [PAP], and then press
OK.
Depending on your Authentication Method, the Inner Authentication Method selections differ.
Press a or b to select the Encryption Type [TKIP+AES] or [AES], and then press OK.
Press a or b to select the Verification Method [No Verification], [CA] or [CA+Server ID], and
then press OK.
- If you selected the [CA+Server ID] option, enter the server ID, user ID and password (if required),
and then press OK for each option.
- For other selections, enter the user ID and the Password, and then press OK for each option.
If you have not imported a CA certificate into your machine, the machine will display the message [No
Verification].
• If you selected the [EAP-TLS] option, press a or b to select the Encryption Type [TKIP+AES] or [AES],
and then press OK.
When the machine displays a list of available Client Certificates, select the certificate you want.
Press a or b to select the Verification Method [No Verification], [CA] or [CA+Server ID], and
then press OK.
- If you selected the [CA+Server ID] option, enter the server ID and user ID, and then press OK for
each option.
- For other selections, enter the user ID, and then press OK.
If you have not imported a CA certificate into your machine, the machine will display the message [No
Verification].
11. To apply the settings, press a to select [Yes], and then press OK. To cancel, press b to select [No].
12. The machine will attempt to connect to the wireless device you have selected.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
96