User's Manual
Table Of Contents
- Online User's Guide HL-L8260CDW/HL-L8360CDW/HL-L8360CDWT
- Table of Contents
- Before You Use Your Brother Machine
- Introduction to Your Brother Machine
- Paper Handling
- Print
- Print from Your Computer (Windows®)
- Print from Your Computer (Macintosh)
- Cancel a Print Job
- Test Print
- Print Data Directly from a USB Flash Drive
- Network
- Supported Basic Network Features
- Network Management Software and Utilities
- Additional Methods of Configuring Your Brother Machine for a Wireless Network
- Before Configuring Your Brother Machine for a Wireless Network
- Configure Your Machine for a Wireless Network
- Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Machine for a Wireless Network Using the PIN Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Machine for a Wireless Network Using the Machine's Control Panel Setup Wizard
- Configure Your Machine for a Wireless Network When the SSID Is Not Broadcast
- Configure Your Machine for an Enterprise Wireless Network
- Use Wi-Fi Direct®
- Print from Your Mobile Device Using Wi-Fi Direct
- Configure Your Wi-Fi Direct Network
- Wi-Fi Direct Network Configuration Overview
- Configure Your Wi-Fi Direct Network Using the One-Push Method
- Configure Your Wi-Fi Direct Network Using the One-Push Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Wi-Fi Direct Network Using the PIN Method
- Configure Your Wi-Fi Direct Network Using the PIN Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Wi-Fi Direct Network Manually
- Advanced Network Features
- Technical Information for Advanced Users
- Security
- Lock the Machine Settings
- Network Security Features
- Before Using Network Security Features
- Secure Function Lock 3.0
- Use Active Directory® Authentication
- Use LDAP Authentication
- Manage Your Network Machine Securely Using SSL/TLS
- Introduction to SSL/TLS
- Certificates and Web Based Management
- Supported Security Certificate Features
- Create and Install a Certificate
- Manage Multiple Certificates
- Manage Your Network Machine Securely Using Web Based Management
- Manage Your Network Machine Securely Using BRAdmin Professional 3 (Windows®)
- Print Documents Securely Using SSL/TLS
- Manage Your Network Machine Securely Using IPsec
- Send an Email Securely
- Use IEEE 802.1x Authentication for a Wired or a Wireless Network
- Store Print Log to Network
- Mobile/Web Connect
- Brother Web Connect
- Google Cloud Print
- AirPrint
- Mobile Printing for Windows®
- Mopria® Print Service
- Brother iPrint&Scan
- Near-Field Communication (NFC)
- Troubleshooting
- Routine Maintenance
- Machine Settings
- Appendix
Home > Routine Maintenance > Clean the Machine > Clean the Drum Unit
Clean the Drum Unit
If your printout has black or white dots or other repeating marks at 3.7 in. (94 mm) intervals, the drum may
have foreign material, such as glue from a label, stuck on the drum surface.
>> HL-L8260CDW
>> HL-L8360CDW/HL-L8360CDWT
HL-L8260CDW
1. Make sure the machine is in Ready Mode.
2. Press a or b to select the following:
a. Select [Print Reports]. Press OK.
b. Select [Drum Dot Print]. Press OK.
The machine prints the Drum Dot Check Sheet.
3. Press and hold to turn off the machine.
4. Press the front cover release button and pull open the front cover.
5. Hold the drum unit's green handle. Pull the drum unit out of the machine until it stops.
6. Turn the green lock lever (1) counterclockwise until it locks in the release position. Holding the green handles
of the drum unit, lift the front of the drum unit and remove it from the machine.
2
1
IMPORTANT
Hold the green handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.
334