User Manual
Table Of Contents
- User’s Guide HL-L9200CDWT/HL-L9300CDWTT
- For HL-L9300CDWTT users
- User's Guides and where do I find them?
- Using the documentation
- Accessing Brother Utilities (Windows®)
- Table of Contents
- 1 Printing Methods
- About this Machine
- Acceptable paper and other print media
- Loading paper
- 2-sided printing
- Printing from a USB flash drive or digital camera supporting mass storage
- 2 Driver and Software
- Printer driver
- Windows®
- Macintosh
- Software
- 3 General Information
- 4 Options
- 5 Routine Maintenance
- 6 Troubleshooting
- A Appendix
- Index
General Information
99
3
Network
(Continued)
WLAN TCP/IP Boot Method
Auto* / Static / RARP /
BOOTP / DHCP
Chooses the IP
method that best
suits your needs.
IP Address ###.###.###.###
(000.000.000.000)*
1
Enter the IP
address.
Subnet Mask ###.###.###.###
(000.000.000.000)*
1
Enter the Subnet
mask.
Gateway ###.###.###.###
(000.000.000.000)*
1
Enter the Gateway
address.
IP Boot
Tries
0 / 1 / 2 / 3* / ... / 32767
Specifies the
number of
attempts the
machine will try to
obtain an IP
address when the
Boot Method is
set to any setting
except Static.
APIPA
On* / Off
Automatically
allocates the IP
address from the
link
-local address
range.
1
IPv6
On / Off*
Enables or
Disables the IPv6
protocol.
WLAN
Assistant
--
(Windows
®
only)
You can configure
your wireless
network settings
using the Brother
CD-ROM.
Setup Wizard - - Configures the
wireless network
settings using the
setup wizard.
WPS/AOSS - - Configures the
wireless network
settings using
WPS or AOSS™
method.
Level 1 Level 2 Level 3 Level 4 Options Descriptions
The factory settings are shown in Bold with an asterisk.