User Manual
Table Of Contents
- User’s Guide HL-L9200CDWT/HL-L9300CDWTT
- For HL-L9300CDWTT users
- User's Guides and where do I find them?
- Using the documentation
- Accessing Brother Utilities (Windows®)
- Table of Contents
- 1 Printing Methods
- About this Machine
- Acceptable paper and other print media
- Loading paper
- 2-sided printing
- Printing from a USB flash drive or digital camera supporting mass storage
- 2 Driver and Software
- Printer driver
- Windows®
- Macintosh
- Software
- 3 General Information
- 4 Options
- 5 Routine Maintenance
- 6 Troubleshooting
- A Appendix
- Index
Routine Maintenance
134
5
Replacing the drum unit 5
IMPORTANT
• While removing the drum unit, handle it carefully because it may contain toner. If toner scatters on your
hands or clothes, immediately wipe or wash it off with cold water.
• Every time you replace the drum unit, clean the inside of the machine (see Cleaning and Checking the
machine on page 153).
When you replace the drum unit with a new one, follow these steps, and then reset the drum counter by
following the instructions included with the new drum unit.
a Make sure that the machine is turned on.
b Press the front cover release button and pull open the front cover.
c Hold the blue handle of the drum unit. Pull the drum unit out until it stops.