User Manual
Table Of Contents
- Product Safety Guide
- How to use this guide:
- Symbols and conventions used in the documentation
- Compilation and Publication Notice
- Choose a safe location for your product
- General precautions
- Connecting the product safely
- Important Safety Instructions
- Servicing the product
- Product Warranty & Liability
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Other Information
- Brother customer service
- Unlawful use of copying equipment (MFC and DCP only)
4
DO NOT put the product in a location that blocks or obstructs any slot or opening in the product.
These slots and openings are provided for ventilation. Blocking the product’s ventilation could
create a risk of overheating and/or fire.
Instead:
• Keep a gap of at least 100 mm between the ventilation hole and the wall.
• Place the product on a solid level surface.
• DO NOT place this product near or over a radiator or heater.
• DO NOT place this product in a “built-in” installation unless adequate ventilation is provided.
Keep a minimum gap around the machine as shown in the illustration.
(HL only)
(MFC and DCP only)
100 mm 250 mm100 mm
200 mm
100 mm
250 mm
100 mm
400 mm