User Manual
Table Of Contents
- Product Safety Guide
- How to use this guide:
- Symbols and conventions used in the documentation
- Compilation and Publication Notice
- Choose a safe location for your product
- General precautions
- Connecting the product safely
- Servicing the product
- Product Warranty & Liability
- Approval Information (MFC only)
- Declaration of Conformity (Europe only)
- Declaration of Conformity for R&TTE (Radio and Telecommunications) Directive 1999/5/EC (Europe only) (Applicable to models with telecommunications and/or radio interfaces)
- IEC60825-1:2007 Specification (For 220-240V Models Only)
- Wireless LAN (Models with Wireless LAN function only)
- Disconnect device
- Wiring information (U.K. only)
- NFC (Models with NFC function only)
- LAN connection
- Radio interference
- Recycling information in accordance with the WEEE and Battery Directives
- International ENERGY STAR® Qualification Statement
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Other Information
- Brother customer service
- Unlawful use of copying equipment (MFC and DCP only)
4
DO NOT put the product in a location that blocks or obstructs any slot or opening in the product.
These slots and openings are provided for ventilation. Blocking the product’s ventilation could
create a risk of overheating and/or fire.
Instead:
• Keep a gap of at least 100 mm between the ventilation hole and the wall.
• Place the product on a solid level surface.
• DO NOT place this product near or over a radiator or heater.
• DO NOT place this product in a “built-in” installation unless adequate ventilation is provided.
Keep a minimum gap around the machine as shown in the illustration.
(HL only)
(MFC and DCP only)
100 mm 250 mm100 mm
200 mm
100 mm 250 mm100 mm
400 mm