User Manual

Chapter 7
42
Using remote codes 7
Remote Activation Code 7
If you answer a fax call on an extension
telephone, you can tell your machine to
receive it by dialling the Remote Activation
Code l 51. Wait for the chirping sounds then
replace the handset. (See Fax Detect
on page 37.)
If you answer a fax call at the external
telephone, you can make the machine
receive the fax by pressing Mono Start and
choose 2.Receive.
Remote Deactivation Code 7
If you receive a voice call and the machine is
in F/T mode, it will start to sound the F/T Ring
(fast double-ring) after the initial ring delay. If
you pick up the call on an extension
telephone you can turn the F/T Ring off by
pressing #51 (make sure you press this
between the rings).
If the machine answers a voice call and fast
double-rings for you to take over, you can
take the call at the external telephone by
pressing Tel/R.
Changing the remote codes 7
If you want to use Remote Activation, you
have to turn on the remote codes. The preset
Remote Activation Code is l 51. The preset
Remote Deactivation Code is #51. If you
want to, you can replace them with your own
codes.
a Press Menu, 2, 1, 4.
1.Setup Receive
4.Remote Codes
b Press a or b to choose On (or Off).
Press OK.
c Enter the new Remote Activation Code.
Press OK.
d Enter the new Remote Deactivation
Code.
Press OK.
e Press Stop/Exit.
Note
• If you are always disconnected when
accessing your external TAD remotely, try
changing the Remote Activation Code
and
Remote Deactivation Code to
another
three
- digit code using the numbers 0 - 9 , , # .
• Remote Codes might not work with some
telephone systems.