User's Guide
Table Of Contents
- USER'S GUIDE MFC-3420C/MFC-3820CN
- Brother numbers
- Ordering accessories and supplies
- Safety precautions
- Choosing a location
- Quick Reference Guide
- Table of Contents
- 1 Introduction
- 2 Loading originals and paper
- 3 On-screen programming
- 4 Getting started
- 5 Setup Receive
- 6 Setup Send
- 7 Quick-Dial numbers and dialing options
- 8 Remote Fax Options
- 9 Printing reports
- 10 Making copies
- 11 Walk-Up PhotoCapture Center™ (MFC-3820CN only)
- 12 Important information
- Standard telephone and FCC Notices These notices are in effect on models sold and used in the Uni...
- ˘˘Federal Communications Commission (FCC) Declaration of Conformity (USA only)
- Industry Canada Compliance Statement (Canada only)
- LAN connection
- International ENERGY STAR® Compliance Statement
- ˘Important safety instructions
- Trademarks
- 13 Troubleshooting and routine maintenance
- Glossary
- Specifications
- Index
- Remote Retrieval Access card
- brother
11 - 4 WALK-UP PHOTOCAPTURE CENTER
™
(MFC-3820CN ONLY)
The MFC can only read one Media card at a time so do not insert
more than one card. The settings that you want to use with the card
will be kept until you take out the media card from the drive (slot),
print images or press
Stop/Exit
.
1
Insert the media card firmly into the media drive (slot).
2
When you insert your media card
into the proper slot, the LCD shows.
3
Press
PhotoCapture
.
The LCD shows:
Do NOT unplug the power cord or remove the media card from
the media drive (slot) while the MFC is reading or writing to the
card (the
PhotoCapture
key is blinking). You will lose your
data or damage the card.
The media active message will be shown for 60 seconds and
then disappear. Even in that case, you can enter the
PhotoCapture mode by pressing
PhotoCapture
.
(See Printing images on
page 11-6.)
(See
Printing images
on
page 11-6.)
C.Flash Active
Press PhotoCapture key...
Photo:Select ▲▼
Print Index ▲▼
Print Images ▲▼
Select