Installation Instructions

25
For Wireless Network Users
Wireless Network
15
Confirm your network environment (Infrastructure Mode)
The following instructions will offer two methods for installing your Brother machine in a wireless network
environment. Both methods are for infrastructure mode, using a wireless access point/router that uses DHCP to
assign IP addresses. Choose a configuration method and proceed to the page indicated.
a If your wireless access point/router does not support Wi-Fi Protected Setup™ or AOSS™, write
down the wireless network settings of your wireless access point/router in the area below.
IMPORTANT
If you do not know this information (Network Name (SSID/ESSID), and Password), you cannot
continue the wireless setup. You should see the documentation provided with your wireless
access point/router, consult the router manufacturer, or your system administrator.
Item Record the current wireless network settings
Network Name: (SSID/ESSID)
Password
Your Brother machine supports the use of the first WEP KEY only. If you are using a router that is using
more than one WEP KEY enter the KEY used for the first WEP KEY.
Now go to
page 26
b If your wireless access point/router supports automatic wireless (one-push) setup (Wi-Fi Protected
Setup™ or AOSS™)
Now go to
page 28