Operation Manual

Printing photos from a memory card or USB Flash memory drive
107
12
Remove Red-Eye 12
The machine detects eyes in your photos and
will attempt to remove red-eye from your photo.
Note
There are some cases when red-eye may
not be removed.
•
When the face is too small in the image.
• When the face is turning too far up,
down, left or right.
a Make sure you have put a memory card
or USB Flash memory drive in the
correct slot.
Press (Photo Capture).
b Press a or b to choose
Enhance Photos.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose
Remove Red-Eye.
Press OK.
 When Remove Red-Eye is
successful, the photo with the effect
is shown. The adjusted part is shown
in a red frame.
 When Remove Red-Eye is
unsuccessful,
Unable to Detect. is shown.
Press OK to go back to the previous
level.
Note
Press # to try Remove Red-Eye once
again.
e Press OK and a or b to increase or
decrease the number of copies.
f Do one of the following.
 Press OK and change the print
settings. (See page 110.)
 If you do not want to change any
settings, press Colour Start to print.
Monochrome 12
You can convert your photo to monochrome.
a Make sure you have put a memory card
or USB Flash memory drive in the
correct slot.
Press (Photo Capture).
b Press a or b to choose Enhance Photos .
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose Monochrome.
Press OK.
e Press OK and a or b to increase or
decrease the number of copies.
f Do one of the following.
 Press OK and change the print
settings. (See page 110.)
 If you do not want to change any
settings, press Colour Start to print.
Sepia 12
You can convert the colour of your photo to sepia.
a Make sure you have put a memory card
or USB Flash memory drive in the
correct slot.
Press (Photo Capture).
b Press a or b to choose Enhance Photos .
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose Sepia.
Press OK.
e Press OK and a or b to increase or
decrease the number of copies.
f Do one of the following.
 Press OK and change the print
settings. (See page 110.)
 If you do not want to change any
settings, press Colour Start to print.