User Manual
Table Of Contents
- SOFTWARE USER’S GUIDE
- Table of Contents
- Windows®
- 1 Printing
- 2 Scanning
- Scanning a document using the TWAIN driver
- Scanning a document using the WIA driver (For Windows® XP/Windows Vista®)
- Scanning a document using the WIA driver (For Windows Photo Gallery and Windows Fax and Scan users)
- Using the Scan key (For USB cable users)
- Using ScanSoft™ PaperPort™ 11SE with OCR by NUANCE™
- 3 ControlCenter3
- 4 Network Scanning (For models with built-in network support )
- 5 Remote Setup (Not available for DCP models, MFC-250C and MFC-290C)
- 6 Brother PC-FAX Software (MFC models only)
- 7 PhotoCapture Center®
- 8 Firewall settings (For Network users)
- Apple® Macintosh®
- 9 Printing and Faxing
- 10 Scanning
- 11 ControlCenter2
- 12 Network Scanning (For models with built-in network support )
- 13 Remote Setup & PhotoCapture Center®
- Index
- brother USA
Network Scanning (For models with built-in network support)
233
12
Factory reset 12
You can reset Quality, File Type, Glass ScanSize and File Name to the factory settings.
a Press the (Scan) key.
b Press a or b to choose Scan to FTP.
Press OK.
c Press a or b to choose <Manual>.
Press OK.
Note
If there is no FTP Profile configured, skip c and go to d.
d Enter the FTP host address (for example ftp.example.com up to 60 characters) or the IP address (for
example 192.23.56.189).
Press OK.
e Enter the destination folder (for example /brother/abc/, up to 60 characters).
Press OK.
f Enter the username. Press OK.
g Enter the password. Press OK.
h Press a or b to choose Factory Reset.
Press OK.
i Press 1 to choose Yes.
j Press Stop/Exit.