Installation Instructions

Gently push the ink cartridge until it clicks. After

all the ink cartridges are installed close the ink

cartridge cover.

Check the print quality

a When the preparation process has finished, the

LCD shows this message

Press Colour Start.

b Check the quality of the four colour blocks a

on the sheet. (black/yellow/cyan/magenta)

c If all lines are clear and visible, press Yes to

finish the quality check.

If you can see missing short lines, press No and

go to d.

d The LCD asks you if the print quality is OK for

black and colour. Press Yes or No.

After pressing Yes or No for both black and

colour, the LCD shows:

e Press Colour Start, the machine will then start

cleaning the colours.

f After cleaning is finished, press Colour Start.

The machine starts printing the Print Quality

Check Sheet again. Go back to b.

Note

The machine will prepare the ink tube system for

printing. This process will take approximately four

minutes. Do not turn off the machine.

Important

Make sure you put paper in the upper tray for

the initial setup.

Set Paper and Press Start

OK OK

Poor Poor

Black OK?

Yes No

Start Cleaning?

Press Start