User guide

Chapter 11
96
f Do one of the following:
 If you want to use a document as the
watermark, press Scan.
Place the document that you want to
use for the watermark on the scanner
glass and press Mono Start or
Color Start.
The scanned data will be shown on
the LCD.
If you want to adjust the degree of
Transparency for your scanned data,
press Transparency.
Press d or c to adjust the degree,
and then press OK.
If you do not want to adjust the
transparency or have finished
adjusting it, press OK and remove the
watermark document that you
scanned.
Go to step g.
 If you want to use data from a media
card or USB Flash memory drive as
the watermark, insert the media card
or USB flash memory drive.
After Photo Capture stops blinking,
press Media.
The image will be shown on the LCD.
Press the image you want to use for
the watermark.
Change other watermark settings
from the available options as
needed.
Press OK.
Go to step g.
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while
Photo Capture is blinking to avoid
damaging the card, USB Flash memory
drive or data stored on the card.
g Press OK to confirm to use watermark.
Load your document.
h Enter the number of copies you want.
i If you do not want to change additional
settings, press Mono Start or
Color Start.
Duplex (2-sided) copying
(Tray #1 only) 11
You can reduce the amount of paper used for
copies by copying on both sides of the paper.
We recommend you load your document in
the ADF for duplex copying (single-sided
document only). For 2-sided documents and
books use the scanner glass.
(long edge flip)
Portrait
Landscape
(short edge flip)
Portrait
Landscape
1
2
1
1
2
1
1
2
1
2
1
2
1
1
2
1
1
2
1
2