User Manual

82
Cover is Open The ADF cover is not completely
closed.
Close the ADF cover of the machine.
The ADF is open while loading a
document.
Close the ADF cover of the machine, then
press Stop/Exit.
Cover is Open The fuser cover is not completely
closed or paper was jammed in
the back of the machine when
you turned on the power.
 Close the fuser cover of the machine.
 Make sure paper is not jammed inside
the back of the machine, and then close
the fuser cover and press Start.
Disconnected The other person or other
person’s fax machine stopped the
call.
Try to send or receive again.
Document Jam The document was not inserted
or fed correctly, or the document
scanned from the ADF was too
long.
See Document is jammed in the top of the
ADF unit on page 88 or Using the automatic
document feeder (ADF) on page 23.
Drum Error The corona wire on the drum unit
needs to be cleaned.
Clean the corona wire on the drum unit.
(See Cleaning the corona wire on page 72.)
Drum Stop It is time to replace the drum unit. Replace the drum unit. (See Replacing the
drum unit on page 66.)
DR Mode in Use
(except New Zealand)
The machine is set to Distinctive
Ring mode. You can not change
the Receive Mode from Manual to
another mode.
Set Distinctive Ring to Off.
For Australia, see Telephone Service for
Australia on page 33.
For Other countries, see Distinctive Ringing
(For Singapore and Hong Kong)
on page 36.
Duplex Disabled The duplex tray is removed or is
not properly installed.
Carefully put the duplex tray into the
machine until it clicks into place.
The back of the machine is not
closed completely.
Close the back cover of the machine.
EL Error The machine has a mechanical
problem.
Open the front cover and close it again.
Faxability On
(for New Zealand)
The machine is set to Faxability
mode. You can not change the
Recieve Mode from Manual to
another mode.
Set Faxability to Off.
See FaxAbility on page 34.
Error Message Cause Action