User`s guide
Table Of Contents
- Network USER’S GUIDE
- Table of contents
- 1.Introduction
- 2.Configuring your network printer
- 3.Front Panel Setup
- 4.Network printing from Windows®: basic TCP/IP Peer-to-Peer printing
- 5.Internet printing for Windows®
- 6.Network printing from Macintosh®
- 7.Web Based Management
- 8.Troubleshooting
- Appendix A
- Using services
- Other ways to set the IP address (for advanced users and administrators)
- Using DHCP to configure the IP address
- Using BOOTP to configure the IP address
- Using RARP to configure the IP address
- Using APIPA to configure the IP address
- Using ARP to configure the IP address
- Using the TELNET console to configure the IP address
- Using the Brother Web BRAdmin server software for IIS* to configure the IP address
- Print/Scan Server specifications
- Function Table and Default Factory Settings
- Index
Front Panel Setup
3 - 7
3
Setup Misc.
Ethernet
Ethernet link mode. Auto allows the print/scan server to operate in 100BaseTX full or half duplex, or in
10BaseT full or half duplex mode by auto negotiation.
100BaseTX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BaseT Full Duplex (10B-FD) or Half
Duplex (10B-HD) fix the print/scan server link mode. This change is valid after the print/scan server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print/scan server.
1
Press Menu/Set, 5, 2, 1.
2
Press ▲ or ▼ to select Auto/100B-FD/100B-HD/10B-FD/10B-HD.
3
Press Menu/Set.
4
Press Stop/Exit.
Printing the Network Configuration Page
Note
Node name: Node name appears in the Network Configuration Page. The default Node name is
"BRN_xxxxxx" ("xxxxxx" is the last six digits of Ethernet address.).
The Network Configuration Page prints a report listing all the current network configuration including the
network print/scan server settings.
1
Press Reports.
2
Press ▲ or ▼ to select Network Config.
3
Press Menu/Set.