User`s guide
Table Of Contents
- Network USER’S GUIDE
- Table of contents
- 1.Introduction
- 2.Configuring your network printer
- 3.Front Panel Setup
- 4.Network printing from Windows®: basic TCP/IP Peer-to-Peer printing
- 5.Internet printing for Windows®
- 6.Network printing from Macintosh®
- 7.Web Based Management
- 8.Troubleshooting
- Appendix A
- Using services
- Other ways to set the IP address (for advanced users and administrators)
- Using DHCP to configure the IP address
- Using BOOTP to configure the IP address
- Using RARP to configure the IP address
- Using APIPA to configure the IP address
- Using ARP to configure the IP address
- Using the TELNET console to configure the IP address
- Using the Brother Web BRAdmin server software for IIS* to configure the IP address
- Print/Scan Server specifications
- Function Table and Default Factory Settings
- Index
Front Panel Setup
3 - 8
3
Restoring the network settings to factory default
If you wish to reset the print/scan server back to its default factory settings (resetting all information such as
the password and IP address information), please follow these steps:
1
Make sure the machine is not operating, then disconnect all the cables from the machine (except power
cable).
2
Press Menu/Set, 5, 0.
3
Press 1 to select Reset.
4
Press 1 to select Yes.
5
The machine will re-start, re-connect cables once this is complete.