User`s guide
Table Of Contents
- Network USER’S GUIDE
- Table of contents
- 1.Introduction
- 2.Configuring your network printer
- 3.Front Panel Setup
- 4.Network printing from Windows®: basic TCP/IP Peer-to-Peer printing
- 5.Internet printing for Windows®
- 6.Network printing from Macintosh®
- 7.Web Based Management
- 8.Troubleshooting
- Appendix A
- Using services
- Other ways to set the IP address (for advanced users and administrators)
- Using DHCP to configure the IP address
- Using BOOTP to configure the IP address
- Using RARP to configure the IP address
- Using APIPA to configure the IP address
- Using ARP to configure the IP address
- Using the TELNET console to configure the IP address
- Using the Brother Web BRAdmin server software for IIS* to configure the IP address
- Print/Scan Server specifications
- Function Table and Default Factory Settings
- Index
Network printing from Macintosh®
6 - 2
6
6
At this point we must select the correct PPD file for the machine and also configure the correct LPR
information. Click Change in the PostScript Printer Description (PPD) File section and select the
appropriate PPD file for your model.
7
Now select the Change button below the LPR Printer Selection text.
8
You must then enter the IP address and service name
details of the machine. When specifying the Queue, use
the value brn_xxxxxx_p1_at where xxxxxx are the
last 6 digits of the Ethernet address.
Note
If you do not specify the correct value the machine may not
print, or it may not print the data correctly. Please ensure that
the value you enter here matches with the Service name of
the machine.
9
Click OK to go back to the previous screen.
10
You are now ready to create the printer for use. To do
that, click Create and you will see the following:
11
Enter the name of the printer in the Save desktop
printer As: option and click Save.
12
We must now make this our default printer by clicking the printer name once and then select Printing
and Set Default Printer.
Whenever you send a print job, the printer that you just created will be used.