User`s guide
Table Of Contents
- Network USER’S GUIDE
- Table of contents
- 1.Introduction
- 2.Configuring your network printer
- 3.Front Panel Setup
- 4.Network printing from Windows®: basic TCP/IP Peer-to-Peer printing
- 5.Internet printing for Windows®
- 6.Network printing from Macintosh®
- 7.Web Based Management
- 8.Troubleshooting
- Appendix A
- Using services
- Other ways to set the IP address (for advanced users and administrators)
- Using DHCP to configure the IP address
- Using BOOTP to configure the IP address
- Using RARP to configure the IP address
- Using APIPA to configure the IP address
- Using ARP to configure the IP address
- Using the TELNET console to configure the IP address
- Using the Brother Web BRAdmin server software for IIS* to configure the IP address
- Print/Scan Server specifications
- Function Table and Default Factory Settings
- Index
Troubleshooting
8 - 5
8
4
If you have tried 1 to 4 above and it does not work, then reset the print/scan server back to the default
factory settings and try from the initial setup again. For information how to reset to the default factory
settings, see Restoring the network settings to factory default on page 3-8
Error during printing
If you try to print while other users are printing large amounts of data (e.g. many pages or color pages with
high resolution), the printer is unable to accept your print job until the ongoing printing is finished. If the waiting
time of your print job exceeds a certain limit, a time out situation occurs, which causes the error message. In
such situations, execute the print job again after the other jobs are completed.
Protocol-specific troubleshooting
Windows
®
98/98SE/Me and Windows NT
®
4.0 Peer-to-Peer print (LPR)
troubleshooting
If you are having trouble printing on a Windows
®
98/98SE/Me, Windows NT
®
4.0 or later Peer-to-Peer
network (LPR method), check the following:
1
Make sure that the Brother LPR Port driver is correctly installed and configured according to the
Windows
®
98/98SE/Me or Windows NT
®
4.0 Peer-to-Peer chapters.
2
Try to turn the Byte Count on in the Configure port area of printer driver properties.
You may find that during the installation of BLP software, the screen that prompts you for a Port name is not
displayed. This may happen on some Windows
®
98/98SE/Me and Windows NT
®
4.0 computers. Press the
ALT and TAB keys to make it appear.