Copier User Manual

For Network Users

How to set the machine’s

network settings to wireless

LAN or wired LAN

To connect your Brother machine to a wireless or

wired network you must configure the machine from

the machine’s control panel for the network type you

are using.

For wireless LAN

On your machine, press Menu, 6, 2, 5 then press

or to choose On, and then press OK.

For wired LAN

On your machine, press Menu, 6, 1, 4 then press

or to choose On, and then press OK.

Note

In case that you choose On for both wireless LAN

and wired LAN, if the network cable is connected

to the machine, the wired network interface will be

active. If the cable is not connected to the

machine, the wireless network interface will be

active.

Restoring the network

settings to factory default

To restore all network settings of the internal

Print/Scan server to factory default, please follow the

steps below.

1 Make sure the machine is not operating, then

disconnect all the cables from the machine

(except power cable).

2 Press Menu, 6, 0.

3 Press 1 to select Reset.

4 Press 1 to select Yes.

5 The machine will restart, re-connect cables

once this is complete.