User Manual

Chapter 4
26
Setting the password for the
administrator 4
The password you set in these steps is for the
administrator. This password is used to set
up users and to turn Secure Function Lock on
or off. See Setting up restricted users on page
27 and Turning Secure Function Lock on on
page 27.
a Press Menu, 1, 9, 2.
19.Security
2.Function Lock
New Passwd:
Enter & OK Key
b Enter a four-digit number for the
password. Press OK.
c Re-enter the password when the LCD
shows Verify:. Press OK.
d Press Stop/Exit.
Setting up the Public user 4
You can set up the Public user. Public users
do not need to enter a password.
Note
You must disable at least one function.
a Press Menu, 1, 9, 2.
19.Security
2.Function Lock
a Lock OffiOn
b Set Password
Select
ab & OK
b Press a or b to select Setup User.
Press OK.
c Enter the administrator password.
Press OK.
19.Security
Setup User
a Public
b User01
Select ab & OK
d Press a or b to select Public.
Press OK.
e Press a or b to select Enable or
Disable for Fax Tx. Press OK.
After you have set Fax Tx, repeat this
step for Fax Rx, Copy, Scan and
PCprint
1
. Press OK.
1
You can set PCprint for only the Public user.
f Press Stop/Exit.