User Manual
Table Of Contents
- Quick Setup Guide MFC-8890DW
- Start Here
- 1 Unpack the machine and check the components
- 2 Install the drum unit and toner cartridge assembly
- 3 Load paper in the paper tray
- 4 Release the scanner lock
- 5 Connect the power cord and telephone line
- 6 Choose a Receive Mode
- 7 Set the LCD contrast (If needed)
- 8 Set the date and time
- 9 Enter personal information (station ID)
- 10 Fax Transmission Report
- 11 Set tone or pulse dialling mode
- 12 Set the telephone line type
- 13 Automatic Daylight Savings Time
- 14 Choose your connection type
- For USB Interface Users (Windows® 2000 Professional/XP/XP Professional x64 Edition/ Windows Vista®)
- For USB Interface Users (Mac OS® X 10.3.9 or greater)
- For Parallel Interface Users (Windows® 2000 Professional/XP/XP Professional x64 Edition)
- For Wired Network Interface Users (Windows® 2000 Professional/XP/XP Professional x64 Edition/ Windows Vista®)
- For Wired Network Interface Users (Mac OS® X 10.3.9 or greater)
- For Wireless Network Interface Users
- For Network Users
- Options and Consumables
- brother UK/IRE
- Start Here
32
For Wireless Network Users
h Press or to choose TKIP or AES
for Encryption Type? and press OK.
Enter the WPA/WPA2-PSK password you
wrote down in step 16 on page 30 using the
dial pad to choose each letter or number.
For example, to enter the letter a, press the 2
key on the dial pad once. To enter the number
3, press the 3 key on the dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
(For more information, see Entering Text for
Wireless Settings on page 44.)
Press OK when you have entered all the
characters, then press 1 for Yes to apply your
settings. Go to step k.
i Enter the user name and press OK. You can
use or to move the cursor. For
example, to enter the letter a, press the 2 key
on the dial pad once.
Enter the password and press OK, and then
press 1 to apply your settings. Go to step k.
(For more information, see Entering Text for
Wireless Settings on page 44.)
j Press or to choose TKIP or AES
for Encryption Type? and press OK.
Enter the user name and press OK. You can
use or to move the cursor. For
example, to enter the letter a, press the 2 key
on the dial pad once.
Enter the password and press OK, and then
press 1 to apply your settings. Go to step k.
(For more information, see Entering Text for
Wireless Settings on page 44.)
k Your machine will now try to connect to your
wireless network using the information you
have entered. If successful, Connected will
appear briefly on the LCD.
If your machine does not successfully connect
to your network, verify your network settings
collected in step 16 on page 30, then repeat
steps a to j to make sure you have entered the
correct information.
If your access point does not have DHCP
enabled you will need to manually configure
the IP address, subnet mask and gateway of
the machine to suit your network. See the
Network User’s Guide for details.
To install MFL-Pro Suite, continue to
step 18.
For Windows
®
Users:
Now go to
page 35
For Macintosh
®
Users:
Now go to
page 39
Wireless setup is now complete. A four
level indicator at the top of your
machine’s LCD will show the wireless
signal strength of your access point or
router.