Network User's Guide

87
7
7
Overview 7
The LDAP protocol allows you to search for information such as fax numbers and E-mail addresses from your
server. When you use Fax, I-Fax or Scan to E-mail server features, you can use the LDAP search to find fax
numbers or E-mail addresses.
Changing the LDAP configuration using a Browser 7
You can configure and change LDAP settings using a web browser. (For more information, see Changing the
LDAP configuration using a web browser (For DCP-9270CDN and MFC-9970CDW) on page 86.)
LDAP operation using the control panel 7
After you configure LDAP settings, you can use the LDAP search to find fax numbers or E-mail addresses for
the following features.
 Fax sending
1
(See the Basic User's Guide for sending operations)
 I-Fax sending
1
(See Internet fax (For MFC-9970CDW) on page 89 for sending operations)
 Scan to E-mail server (See the Software User's Guide for sending operations)
1
For MFC-9970CDW
When you are ready to enter a fax number or E-mail address, follow the steps below:
a Press to search.
b Enter initial characters for your search by using the buttons on the LCD.
Note
• You can enter up to 15 characters.
• For information how to enter text, see the Basic User's Guide.
c Press OK.
The LDAP search result will be shown on the LCD with before the local address book search
result (For MFC-9970CDW).
If there is no match on the server and the local address book (For MFC-9970CDW), the LCD will show
Results cannot be found. for about 60 seconds.
d Press a or b to scroll until you find the name you are looking for.
To confirm the details of the name, press Detail.
LDAP operation
(For DCP-9270CDN and MFC-9970CDW)
7