User Manual
Table Of Contents
- Product Safety Guide
- Symbols and Conventions Used in the Documentation
- Compilation and Publication Notice
- Choose a Safe Location for Your Product
- Connect the Product Safely
- Use the Product Safely
- Important Information for Australia
- Important Information for New Zealand
- Important Information for Some Countries
- Product Warranty & Liability
- Trademarks
- Brother Customer Service
- Unlawful Use of Copying or Scanning Equipment (Products with scanning function only)
- Disclaimer
• If the product exhibits a distinct change in performance, indicating a need for service.
Product Warranty & Liability
Nothing in this guide shall affect any existing product warranty or be construed as granting any
additional product warranty. Failure to follow the safety instructions in this guide may invalidate
your product’s warranty.
WARNING
Only use the power cord supplied with this product (if included in the box).
Disconnect device
This product must be installed near an electrical socket that is easily accessible. In case of an
emergency, you must unplug the power cord from the electrical socket to shut off the power
completely.
LAN Connection (Models with Wired LAN Function Only)
CAUTION
DO NOT connect this product to a LAN connection that is subject to over-voltages.
For WLAN models (Taiwan only)
Caution!
Administrative Regulations on Low Power Radio Waves Radiated Devices
Article 12: Unless granted permission by Taiwan DGT, any company, enterprise or user is not
allowed to change the frequency, enhance the transmitting power or alter the original design
characteristics or operating functions of an approved low-power radio frequency device.
Article 14: Low-power radio frequency devices shall not influence aircraft security or interfere
with legal communications. If such interference occurs, the low-power radio frequency device
must immediately cease operations and may not be resumed until the interference problem has
been resolved. The above-mentioned “legal communications” is defined as radio communication
operations that conform to the Telecommunications Act. Low-power radio-frequency devices
must accept any interference received from legal communications, and Industrial, Scientific and
Medical (ISM) radio wave devices.
18