User Manual
Table Of Contents
- SOFTWARE USER’S GUIDE
- Table of Contents
- Windows®
- Printing
- Using the Brother printer driver
- Features
- Choosing the right type of paper
- Simultaneous printing, scanning and faxing
- Clearing data from the memory
- Status Monitor
- Printer driver settings
- Accessing the printer driver settings
- Basic tab
- Advanced tab
- Support
- Using FaceFilter Studio for photo printing by REALLUSION
- Scanning
- ControlCenter3
- Remote Setup (Not available for MFC-J220, MFC-J265W and MFC-J410)
- Brother PC-FAX Software
- PhotoCapture Center™
- Firewall settings (For Network users)
- Printing
- Apple Macintosh
- Printing and Faxing
- Scanning
- ControlCenter2
- Remote Setup & PhotoCapture Center™
- Using the Scan key
- Index
- brother CHN-ENG
172
12
12
Using the Scan key over a USB cable connection 12
Note
If you use the SCAN key on a network, see Network Scanning (For models with built-in network support)
on page 180.
You can use the (SCAN) key on the control panel to scan documents directly into your word
processing, graphics or E-mail applications, to a folder on your computer, to a memory card or USB Flash
memory drive.
Before you can use the (SCAN) key on the control panel, you have to install the Brother MFL-Pro
software suite and connect the machine to your computer. If you installed the Brother MFL-Pro software suite
from the included CD-ROM, then the correct drivers and the ControlCenter software are installed. Scanning
using the (SCAN) key uses the configuration of the Device Button tab of the ControlCenter software.
(For Windows
®
, see SCAN on page 54. For Macintosh, see SCAN on page 149.) For details about how to
configure the scan settings and to launch the application of your choice using the (SCAN) key, see
Using ControlCenter3 on page 51 (Windows
®
) or ControlCenter2 on pages 147 (Macintosh).
USB cable scanning 12