User Manual

Secure Network Access
Your machines default password is on the label on the back
of the machine (preceded by "Pwd").
We strongly recommend you change it to protect your
machine from unauthorised access.
NOTE
• Most of the illustrations in this Quick Setup Guide show the MFC-J491DW.
• Save all packing materials and the box in case you must ship your
machine.
• You must purchase the correct interface cable for the interface you
want to use.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
2
Load paper in the paper tray
1
Unpack the machine and check the components
The components included in the box may differ depending on your country.
Remove the protective tape and film covering the machine.
Follow the steps on the LCD
to unpack and install the ink
cartridges.
The machine will prepare the ink
tube system for printing.
When the machine has finished the initial cleaning
process, follow the steps on the LCD to configure
the machine’s settings.
• Check print quality
• Set Firmware Update defaults
• Print the installation sheet
Open the ink cartridge cover, and then
remove the orange protective part
from the machine.
After turning the machine on, you may need to set your
country or language (depending on your machine).
If required, follow the on-screen instructions.
NOTE
You can adjust the control panel angle to read the
LCD more easily.
NOTE
Do not throw away the orange protective part.
You will need it if you transport the machine.
Quick Setup Guide
DCP-J572DW / MFC-J491DW
Read the Product Safety Guide first, then read this Quick Setup Guide
for the correct installation procedure.
3
Connect the power cord
6
Install the inbox ink cartridges
4
Select your country
or language
(Initial setup only)
7
Machine settings
D01D61001-01
OCE/ASA
Version B
(Australia
only)
(Hong Kong
only)
Inbox Ink Cartridges*
• Black
• Yellow
• Cyan
• Magenta
*
Ink cartridges contain
approximately the
same page yield as
replacement cartridges
(Standard).
Quick Setup Guide
Product Safety Guide
Power Cord Telephone Line Cord
Adapter
(MFC models only)
Brother Installation
Disc
Telephone Line Cord
(MFC models only)
1. Press Settings.
2. Press a or b to select the following:
a. Select [Initial Setup], and then press OK.
b. Select [Local Language], and then press OK.
c. Select your language, and then press OK.
3. Press Stop/Exit.
8
Select your language
(if needed and only for
certain models)
9
Connect the telephone line cord (MFC models only)
If you are not using your machine as a fax, go to
10
.
For more information on using the fax feature, see the Online User’s Guide.
The latest manuals are available at the Brother Solutions Center:
support.brother.com/manuals
Watch our FAQ videos for help
with setting up your Brother
machine.
support.brother.com/videos
5
Set the date and time
Follow the prompts displayed on the LCD to set the
date and time.
Quickly shake just the black
ink cartridge horizontally
15 times as shown, before
inserting it into the machine.
Open the output paper tray
cover a. Fan the paper well and load it in the tray.
Close the output paper tray cover, and
then slowly push the tray completely
into the machine.
Adjust the paper guides.
NOTE
Pull out the paper support a, and unfold
thepapersupportapb so that the
printed pages do not fall.
(Example for Australia)
(Example for Australia)

Summary of content (2 pages)