Quick Setup Guide
Table Of Contents
- Quick Setup Guide MFC-J6510DW MFC-J6710DW
- Start Here
- 1 Unpack the machine and check the components
- 2 Load plain Letter/A4 paper
- 3 Connect the power cord and telephone line
- 4 Install the ink cartridges
- 5 Check the print quality
- 6 Set the paper settings
- 7 Wireless setup (if needed)
- 8 Choose your language (if needed)
- 9 Choose the correct Receive Mode
- 10 Set the date and time
- 11 Set your Station ID
- 12 Fax Transmission Report
- 13 Set Tone or Pulse dialing mode (Canada only)
- 14 Set the telephone line compatibility
- 15 Automatic Daylight Savings Time
- 16 Send in the Product Registration Sheet (USA only)
- 17 Manual Feed Slot
- 18 Choose your connection type
- For USB interface users (Windows® 2000 Professional/XP Home/XP Professional/Windows Vista®/Windows® 7)
- For USB interface users (Mac OS X 10.4.11, 10.5.x, 10.6.x)
- For wired network interface users (Windows® 2000 Professional/XP Home/XP Professional/Windows Vista®/Windows® 7)
- For wired network interface users (Mac OS X 10.4.11, 10.5.x, 10.6.x)
- For wireless network interface users
- 19 Before you begin
- 20 Choose your wireless setup method
- 21 Manual setup from the control panel using the Setup Wizard (Macintosh, Mobile Devices and Windows®)
- 21 One-push Setup using WPS or AOSS™ (Windows® and Macintosh)
- Troubleshooting
- Install the drivers & software (Windows® 2000 Professional/XP Home/XP Professional/Windows Vista®/Windows® 7)
- Install the drivers & software (Mac OS X 10.4.11, 10.5.x, 10.6.x)
- Install Optional Applications Windows®
- For Network Users
- Consumables
- brother USA/CAN
- Start Here
3
d Fan the stack of paper well to avoid paper jams
and misfeeds.
e Gently put the paper into the paper tray (For
MFC-J6710DW, tray #1) print side down and
top edge first.
f Gently adjust the paper side guides to the
paper with both hands. Make sure that the
paper side guides touch the edges of the
paper.
g Close the output paper tray cover. Check that
the paper is flat in the tray and below the
maximum paper mark a.
h Slowly push the paper tray completely into the
machine.
i While holding the paper tray in place, pull out
the paper support a until it clicks, and then
unfold the paper support flap b.
Note
DO NOT push the paper in too far.
1
Note
(For MFC-J6710DW)
For information about tray #2 (the lower tray), see
Loading paper in paper tray #2 in chapter 2 of the
Basic User’s Guide.
1
2