Quick Setup Guide
Table Of Contents
- Quick Setup Guide MFC-J6510DW MFC-J6710DW
- Start Here
- 1 Unpack the machine and check the components
- 2 Load plain Letter/A4 paper
- 3 Connect the power cord and telephone line
- 4 Install the ink cartridges
- 5 Check the print quality
- 6 Set the paper settings
- 7 Wireless setup (if needed)
- 8 Choose your language (if needed)
- 9 Choose the correct Receive Mode
- 10 Set the date and time
- 11 Set your Station ID
- 12 Fax Transmission Report
- 13 Set Tone or Pulse dialing mode (Canada only)
- 14 Set the telephone line compatibility
- 15 Automatic Daylight Savings Time
- 16 Send in the Product Registration Sheet (USA only)
- 17 Manual Feed Slot
- 18 Choose your connection type
- For USB interface users (Windows® 2000 Professional/XP Home/XP Professional/Windows Vista®/Windows® 7)
- For USB interface users (Mac OS X 10.4.11, 10.5.x, 10.6.x)
- For wired network interface users (Windows® 2000 Professional/XP Home/XP Professional/Windows Vista®/Windows® 7)
- For wired network interface users (Mac OS X 10.4.11, 10.5.x, 10.6.x)
- For wireless network interface users
- 19 Before you begin
- 20 Choose your wireless setup method
- 21 Manual setup from the control panel using the Setup Wizard (Macintosh, Mobile Devices and Windows®)
- 21 One-push Setup using WPS or AOSS™ (Windows® and Macintosh)
- Troubleshooting
- Install the drivers & software (Windows® 2000 Professional/XP Home/XP Professional/Windows Vista®/Windows® 7)
- Install the drivers & software (Mac OS X 10.4.11, 10.5.x, 10.6.x)
- Install Optional Applications Windows®
- For Network Users
- Consumables
- brother USA/CAN
- Start Here
33
Windows
®
Wireless Network
Windows
®
Macintosh
Wireless Network
d Choose Wireless Network Connection, and
then click Next.
e When this screen appears, choose Change
the Firewall port settings to enable network
connection and continue with the
installation. (Recommended) and click Next.
(Not for Windows
®
2000)
If you are using a firewall other than Windows
®
Firewall or Windows
®
Firewall is off, this screen
may appear.
See the instructions provided with your firewall
software for information on how to add the
following network ports.
For network scanning, add UDP port 54925.
For network PC-Fax receiving, add UDP port
54926.
If you still have trouble with your network
connection, add UDP port 137.
f Choose your machine from the list, and then
click Next.
Note
• If your wireless settings fail, the Wireless
Device Setup Wizard will appear during the
installation of MFL-Pro Suite. Confirm your
settings by following the on-screen
instructions. If you encounter this failure, go to
step 20-a on page 27 and setup the wireless
connection again.
• If you are using WEP and the LCD displayed
Connected but your machine is not found,
make sure you entered the WEP key correctly.
The WEP key is case sensitive.