User Manual

44
For Network Users
Reset the network settings to factory default
To restore all network settings of the internal Print/Scan server to the factory default, please follow the steps below:
a Make sure the machine is idle, then disconnect all the cables from the machine (except the power cord).
b Press .
c Press All Settings.
d Press Network.
e Swipe up or down, or press a or b to display Network Reset.
Press Network Reset.
f Press Yes.
g Hold down Yes for two seconds to confirm.
h The machine will restart, re-connect the cables once this is complete.
Entering Text
Press to cycle between lower case and upper case.
Press to cycle between letters, numbers and special characters. (The characters available may differ
depending on your country.)
To move the cursor to the left or right, press d or c.
Inserting spaces
To enter a space, press Space.
Making corrections
If you entered a number or a character incorrectly and want to change it, press d or c move the cursor under the
incorrect character, and then press . Enter the correct character. Use d or c to go back or forward to insert a
character.