Wi-Fi Direct™ Guide

Configuration methods
11
2
One-push configuration using WPS 2
If your mobile device supports WPS or Push Button Configuration (PBC), follow these steps to configure a
Wi-Fi Direct™ network.
NOTE
When the machine receives the Wi-Fi Direct™ request from your mobile device, the message
Wi-Fi Direct connection request received. will be displayed. Press OK to connect. If this
happens before you reach step j in the instructions that follow, go directly to step j and continue
configuration.
a Press .
b Press All Settings.
c Press s or t to display Network.
Press Network.
d Press Wi-Fi Direct.
e Press s or t to display Group Owner.
f Press Group Owner, and then press On.
g Press Push Button.
h When Wi-Fi Direct On? is displayed, press On to accept.
To cancel, press Off.
i When Activate Wi-Fi Direct on other device. Then Press [OK]. is displayed, activate
your mobile device’s WPS one-push configuration method (see your mobile device’s user’s guide for
instructions) and then press OK on your Brother machine. This will start the Wi-Fi Direct™ setup.
To cancel, press .
j If your mobile device connects successfully, the machine displays the message Connected.
You have completed the Wi-Fi Direct™ network setup. For more information on printing from or scanning
to your mobile device, download the Mobile Print/Scan Guide for Brother iPrint&Scan or the AirPrint
Guide from the Brother Solutions Center (http://solutions.brother.com/
).
If the connection fails, see Troubleshooting on page 15.