Wi-Fi Direct™ Guide
Table Of Contents
- Wi-Fi Direct™ Guide
- Applicable models
- Definitions of notes
- Trademarks
- IMPORTANT NOTE
- Table of Contents
- 1 Introduction
- 2 Configuration methods
- 3 Troubleshooting
- 4 Glossary
- brother ENG
Configuration methods
14
2
k If your mobile device connects successfully, the machine displays the message Connected.
You have completed the Wi-Fi Direct™ network setup. For more information on printing from or scanning
to your mobile device, download the Mobile Print/Scan Guide for Brother iPrint&Scan or the AirPrint
Guide from the Brother Solutions Center (http://solutions.brother.com/).
If the connection fails, see Troubleshooting on page 15.
Manual configuration for a Wi-Fi Direct™ network 2
If your mobile device does not support an automatic Wi-Fi Direct™ connection or WPS, you must configure
a Wi-Fi Direct™ network manually.
a Press .
b Press All Settings.
c Press s or t to display Network.
Press Network.
d Press Wi-Fi Direct.
e Press Manual.
f When Wi-Fi Direct On? is displayed, press On to accept.
To cancel, press Off.
g The machine will show the SSID name and Password for two minutes. Go to the wireless network
settings page of your mobile device and type the SSID name and password.
h If your mobile device connects successfully, the machine displays the message Connected.
You have completed the Wi-Fi Direct™ network setup. For more information on printing from or scanning
to your mobile device, download the Mobile Print/Scan Guide for Brother iPrint&Scan or the AirPrint
Guide from the Brother Solutions Center (http://solutions.brother.com/).
If the connection fails, see Troubleshooting on page 15.