User Manual
Table Of Contents
- Product Safety Guide
- How to use this guide:
- Symbols and conventions used in the documentation
- Table of Contents
- Compilation and Publication Notice
- Choose a safe location for your product
- General precautions
- Connecting the product safely
- Servicing the product
- Important Safety Instructions
- Product Warranty & Liability
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Other Information
- Brother Customer Service
- Unlawful use of copying equipment
- brother CHN-ENG
17
Approval Information
1
THIS EQUIPMENT IS DESIGNED TO WORK WITH A TWO WIRE ANALOGUE PSTN LINE
FITTED WITH THE APPROPRIATE CONNECTOR.
Brother advises that this product may not function correctly in a country other than where it was
originally purchased, and does not offer any warranty in the event that this product is used on
public telecommunication lines in another country.
Notes on Using the Wireless Network Models 1
1 For Wireless LAN Function of the Equipment
Operating frequency: 2.4 - 2.4835 GHz
Equivalent isotropic radiated power (EIRP): ≤ 100 mW
Maximum power spectral density: ≤ 10 dBm / MHz (EIRP)
Carrier frequency tolerance: 20 ppm
Out-of-band emission power (Outside the 2.4 to 2.4835 GHz frequency band)
≤-80 dBm / Hz (EIRP)
Spurious emission (radiation) power (Outside the range of the corresponding carrier ± 2.5
times the channel bandwidth):
≤-36 dBm / 100 kHz (30 - 1000 MHz)
≤-33 dBm / 100 kHz (2.4 - 2.4835 GHz)
≤-40 dBm / 1 MHz (3.4 - 3.53 GHz)
≤-40 dBm / 1 MHz (5.725 - 5.85 GHz)
≤-30 dBm / 1 MHz (1 - 12.75 GHz for others)
2 For NFC function of the Equipment
Operating frequency: 13.553 - 13.567 MHz
The magnetic field strength of emission at the distance of 10 meters away from the
equipment shall not exceed 42 dBμA/m (based on quasi-peak detection mode);
Frequency tolerance: ≤100×10
-6
Spurious radiation: For the equipment within the 13.553-13.567 MHz frequency band, the
offset threshold from the 140 kHz frequency range at the both ends of the frequency band
is 9 dBμA/m (at 10 meters away, quasi-peak).
3 Do not, without appropriate permission, attempt to alter the emission frequency or increase the
emission power (including by installing an additional RF power amplifier), or connect any
external antenna or use any unspecified transmitting antenna.
4 This equipment must not cause harmful interference to other radio services. In case such
interference occurred, the equipment must be stopped immediately and cannot be used until
the appropriate measures are taken to eliminate the harmful interference.
5 This micro-power wireless equipment must accept any interference caused by the legal
operation of other radio services or radiated interference received from the industrial, scientific
and medical appliances.
6 DO NOT use this equipment anywhere near the plane or airport.