Basic User's Guide
Table Of Contents
- Basic User's Guide MFC-J6930DW
- Brother Numbers
- Ordering Accessories and Supplies
- Notice - Disclaimer of Warranties (USA and Canada)
- You Can Use the Following Features
- User's Guides and Where to Find Them
- Basic Operations and Where to Find Instructions
- The Online User's Guide Helps You Get the Most Out of Your Machine
- Questions or Problems? Take a Look at our FAQs, Solutions, and Videos Online.
- Definitions of Notes
- For the Latest Driver Updates
- Compilation and Publication Notice
- Table of Contents
- 1 General Information
- 2 Paper Handling
- 3 Print
- 4 Copy
- 5 Scan
- 6 Fax
- A Routine Maintenance
- B Troubleshooting
- C Appendix
- D Index
Difficulties Suggestions
Left and right margins
are cut off or a single
page is printed on two
pages.
Turn on Auto Reduction.
Dialing does not work.
(No dial tone)
Check all line cord connections.
Change Tone/Pulse setting. (Available only for some countries)
Poor sending quality. Try changing your resolution to Fine or S.Fine.
Make a copy to check your machine’s scanner operation. If the copy
quality is not good, clean the scanner.
See Related Information: Clean the Scanner at the end of this section.
Vertical black lines
when sending.
Black vertical lines on faxes you send are typically caused by dirt or
correction fluid on the glass strip. Clean the glass strip.
See Related Information: Clean the Scanner at the end of this section.
• Choose the Correct Receive Mode on page 29
• Clean the Scanner on page 36
Related Information
54