Network User's Guide
Table Of Contents
- NETWORK USER’S GUIDE
- Applicable models
- Definitions of notes
- Compilation and publication notice
- IMPORTANT NOTE
- Table of Contents
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network
- Overview
- Confirm your network environment
- Wireless configuration temporarily using a USB cable
- Wireless configuration temporarily using an Ethernet cable (For MFC-J825DW/J835DW/J5910DW and DCP-J925DW)
- One push configuration using Wi-Fi Protected Setup or AOSS™
- Configuration using the machine’s control panel Setup Wizard
- Configuration in Ad-hoc Mode
- 4 Control panel setup
- Network menu
- Restoring the network settings to factory default
- Printing the Network Configuration Report
- Printing the WLAN Report
- Function table and default factory settings
- 5 Web Based Management (MFC-J5910DW only)
- 6 Internet fax (MFC-J5910DW only)
- 7 Security features (MFC-J5910DW only)
- 8 Troubleshooting
- Appendix A
- Index
Configuring your machine for a wireless network
17
3
One push configuration using Wi-Fi Protected Setup or
AOSS™ 3
You can use WPS or AOSS™ from the control panel menu to configure your wireless network settings if your
WLAN access point/router (A) supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™.
1
Push Button Configuration
IMPORTANT
• If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.
• If you have previously configured the wireless settings of the machine, you must reset the LAN settings
before you can configure the wireless settings again.
To reset the LAN settings, see Restoring the network settings to factory default uu page 41.
One-push configuration using WPS (Wi-Fi Protected Setup) or AOSS™ 3
For MFC-J425W/J430W/J432W/J435W 3
a Press Menu.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose WPS/AOSS.
Press OK.
d When Enable WLAN? is displayed, press OK to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
A