Network User's Guide
Table Of Contents
- NETWORK USER’S GUIDE
- Applicable models
- Definitions of notes
- Compilation and publication notice
- IMPORTANT NOTE
- Table of Contents
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network
- Overview
- Confirm your network environment
- Wireless configuration temporarily using a USB cable
- Wireless configuration temporarily using an Ethernet cable (For MFC-J825DW/J835DW/J5910DW and DCP-J925DW)
- One push configuration using Wi-Fi Protected Setup or AOSS™
- Configuration using the machine’s control panel Setup Wizard
- Configuration in Ad-hoc Mode
- 4 Control panel setup
- Network menu
- Restoring the network settings to factory default
- Printing the Network Configuration Report
- Printing the WLAN Report
- Function table and default factory settings
- 5 Web Based Management (MFC-J5910DW only)
- 6 Internet fax (MFC-J5910DW only)
- 7 Security features (MFC-J5910DW only)
- 8 Troubleshooting
- Appendix A
- Index
Web Based Management (MFC-J5910DW only)
54
5
How to configure the machine settings using Web Based
Management (web browser) 5
A standard web browser can be used to change your print server settings using the HTTP (Hyper Text
Transfer Protocol).
a Start your web browser.
b Type “http://machine’s IP address/” into your browser’s address bar (where “machine’s IP
address” is the machine’s IP address).
For example:
http://192.168.1.2/
Note
• If you are using a Domain Name System or enable a NetBIOS name, you can enter another name such
as “Shared_Printer” instead of the IP address.
• For example:
http://Shared_Printer/
If you enable a NetBIOS name, you can also use the node name.
• For example:
http://brnxxxxxxxxxxxx/
The NetBIOS name can be seen in the Network Configuration Report. (To learn how to print the Network
Configuration Report, see Printing the Network Configuration Report uu page 42.)
• For Macintosh users, you can have easy access to the Web Based Management System by clicking the
machine icon on the Status Monitor screen. For more information, see the Software User’s Guide.
c You can now change the print server settings.
Note
If you have changed the protocol settings, restart the machine after clicking Submit to activate the
configuration.