Network User's Guide
Table Of Contents
- NETWORK USER’S GUIDE
- Applicable models
- Definitions of notes
- Compilation and publication notice
- IMPORTANT NOTE
- Table of Contents
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network
- Overview
- Confirm your network environment
- Wireless configuration temporarily using a USB cable
- Wireless configuration temporarily using an Ethernet cable (For MFC-J825DW/J835DW/J5910DW and DCP-J925DW)
- One push configuration using Wi-Fi Protected Setup or AOSS™
- Configuration using the machine’s control panel Setup Wizard
- Configuration in Ad-hoc Mode
- 4 Control panel setup
- Network menu
- Restoring the network settings to factory default
- Printing the Network Configuration Report
- Printing the WLAN Report
- Function table and default factory settings
- 5 Web Based Management (MFC-J5910DW only)
- 6 Internet fax (MFC-J5910DW only)
- 7 Security features (MFC-J5910DW only)
- 8 Troubleshooting
- Appendix A
- Index
Security features (MFC-J5910DW only)
72
7
Sending an E-mail with user authentication 7
This machine supports POP before SMTP and SMTP-AUTH methods to send an E-mail via an E-mail server
that requires a user authentication. These methods prevent an unauthorized user from accessing the E-mail
server. You can use Web Based Management and BRAdmin Professional 3 to configure these settings. You
can use POP before SMTP and SMTP-AUTH methods for E-mail Notification, E-mail reports and Internet fax
sending.
E-mail server settings
You need to match the settings of SMTP authentication method with the method used by your E-mail server.
Set the machine's SMTP Server Authentication Method setting to POP before SMTP or SMTP-AUTH
according to the authentication method used by your E-mail server.
Contact your network administrator or your ISP (Internet Service Provider) about the E-mail server
configuration.
SMTP settings
You can change the SMTP port number using Web Based Management. This is useful if your ISP (Internet
Service Provider) implements the “Outbound Port 25 Blocking (OP25B)” service.
If you can use both POP before SMTP and SMTP-AUTH, we recommend choosing SMTP-AUTH.
If you choose POP before SMTP for the SMTP Server Authentication Method, you need to configure the
POP3 settings. You can also use the APOP method if needed.